Contact us

United Kingdom

T: 01403 799979
E: This email address is being protected from spambots. You need JavaScript enabled to view it.


T: 1-703-433-9247
E: This email address is being protected from spambots. You need JavaScript enabled to view it.

Airbag Connector Pull Test


The customer required an easy-to-use system for production staff on the factory floor. Testing needed to be carried out in the minimum amount of time with very little training. The test was required for the connector used in the deployment of car airbags. Rigorous batch testing was necessary as defects have serious implications for safety. Pull test on connector used in car airbags to test safety The welded portion of the connector was pulled to destruction at a constant speed to ensure the best repeatability for results. Data needed to be easy to transmit to the company's SPC (Statistical Process Control) software on their network.


A lower gripping fixture ensured that the operator could instantly fit the airbag connector. A rear locating lug on the connector was pushed into a recess in the fixture with the body of the connector held in place by spring-loaded clips. The upper gripping fixture had a lateral slot into which the connector strip was placed. A toggle clamp at the front of the fixture allowed the operator to quickly secure the strip, ready for testing. The connector strip was pulled at 250mm/min until break. The maximum tension force was recorded on the PFI and then sent to the software. The operator presses the release stud to open the spring-loaded clip at the end of the test, thereby allowing the connector to be quickly removed. The simplicity of this system and the ability to perform rapid testing provided the customer with a complete testing solution.


  • UltraTest Motorised Test Stand (superseded by the MultiTest-dV series)
  • PFI Digital Force Gauge 200 N (superseded by the BFG Basic Force Gauge)

Supplied to

Tyco Electronics, Hungary

We use cookies on our website to ensure that we give you the best user experience.

By continuing to browse our site, you are agreeing to the use of our COOKIES POLICY. Learn more

I understand

A Brand You Can Trust

"The MultiTest 0.5-i is a very good and reliable machine and the Emperor™ Software brings great advantages. It’s a very useful tool for these kinds of tests. It’s fully programmable and offers an in-depth analysis of results. It’s a precious tool for everybody involved, especially those who work with plastics and their mechanical performance"

Nikos Michopoulos, Quality Control, Eurofilm Mantzaris S.A.


Part of the Mecmesin Group
  • "Blogger